Sujet : Re: yardsalin' again
De : muratlanne (at) *nospam* gmail.com (Jim Wilkins)
Groupes : rec.crafts.metalworkingDate : 07. Sep 2024, 02:07:35
Autres entêtes
Organisation : A noiseless patient Spider
Message-ID : <vbg92f$10s8k$1@dont-email.me>
References : 1 2
User-Agent : Microsoft Windows Live Mail 16.4.3505.912
"Snag" wrote in message
news:vbfo4k$uov3$1@dont-email.me...On 9/6/2024 2:44 PM, Snag wrote:
This time the Big Score is a 3 inch 3 jaw chuck on a 5c collet back plate with 3 sets of jaw (all fit) for the princely sum of 10 bucks . A piece of material for a 1 1/2-8 back plate will probably cost more than the chuck . Also got a couple of open/reversible ratchet shorty wrenches for a buck each .
As expected , a piece of 1045 jut the right size set me back $17.50 .
A fully machined back plate would be over 50 bucks ...
-- SnagVoting for Kamabla after Bidenis like changing your shirt becauseyou shit your pants .-------------------------------------
I read somewhere that chuck backplates for threaded spindle lathes should be soft cast iron instead of steel to minimize spindle thread wear.
yardsalin' again
Re: yardsalin' again
