Sujet : Re: yardsalin' again
De : none (at) *nospam* none.com99 (Bob La Londe)
Groupes : rec.crafts.metalworkingDate : 07. Sep 2024, 17:41:49
Autres entêtes
Organisation : A noiseless patient Spider
Message-ID : <vbhvoc$1egij$1@dont-email.me>
References : 1 2 3 4
User-Agent : Mozilla Thunderbird
On 9/6/2024 5:41 PM, Jim Wilkins wrote:
"Bob La Londe" wrote in message news:vbfsur$vcb3$1@dont-email.me...
You have a back plate that fits into a 5C spindle? I have a lathe with
a 5C native spindle. Maybe we could horse trade... if I had a horse.
Bob La Londe
---------------------------------------
LMS sells them, 5478 and 5479, listed with 5C instead of backplates.
https://littlemachineshop.com/products/product_view.php?ProductID=5478&category=
A 5C fixture mount can be an unfinished custom backplate.
Push comes to shove I'd rather trade with Snag than Shars, but he does say his needs some clean up. I have nothing against Shar's. I just like Snag better.
-- Bob La LondeCNC Molds N Stuff-- This email has been checked for viruses by AVG antivirus software.www.avg.com
yardsalin' again
Re: yardsalin' again
