Sujet : Re: Imperial thread on metric lathe!
De : 3668481180e46b1b9364cfc0ae23f9e0 (at) *nospam* example.com (Stecica)
Groupes : rec.crafts.metalworkingDate : 11. Sep 2024, 11:30:03
Autres entêtes
Organisation : NewsgroupDirect
Message-ID : <17f429e0e22f5338$13708$57452$4056de03@news.newsgroupdirect.com>
References : 1 2 3 4
RMS threads are 55 degree cuts; the C mount is 60 degree 1 " x 32tpi of USA origin, UNEF United Extra Fine.
-- For full context, visit https://www.polytechforum.com/metalworking/imperial-thread-on-metric-lathe-20079-.htm
Re: Imperial thread on metric lathe!
Re: Imperial thread on metric lathe!