Re: adjustable square for SHS / box sections

On 2/9/2025 1:10 AM, Richard Smith wrote:

Thanks everyone for all tips.
One is, given saw cutting long lengths of "box" is accurate
transversely
but less so "vertically" due to spring in section and distance outrigger
is from saw, position "flash" at "side" as sawn so have "square" end
as do "measure along" direction AND drill can go through both sides of
"box" on drill-press, not risking hitting "flash" on opposite side.
I will look if adjustable square with a wide "foot" is available.
Would
need a "foot" about 2inches / 50mm wide for when doing big Rectangular
Hollow Sections with big corner radii.
Bigger overall point - thanks a lot everyone.
Regards,
Rich S

>
>
I could make one, but shipping across the pond would probably be a
deal breaker.
>
--
Bob La Londe
CNC Molds N Stuff