Sujet : Re: Batteries - EV Conversion
De : none (at) *nospam* none.com99 (Bob La Londe)
Groupes : rec.crafts.metalworkingDate : 03. Mar 2025, 17:00:51
Autres entêtes
Organisation : A noiseless patient Spider
Message-ID : <vq4jni$1cepf$4@dont-email.me>
References : 1 2 3 4 5 6 7 8 9 10 11 12
User-Agent : Mozilla Thunderbird
On 3/1/2025 8:51 PM, Jim Wilkins wrote:
"Jim Wilkins" wrote in message news:vq0ja8$gj6j$1@dont-email.me...
I needed expensive special tools to crimp the connectors.
They were crimped instead of soldered to better resist vibration. The end of a solder joint is a stress concentration in stranded wire, and copper work-hardens. High current makes wires magnetic and may slam them against steel structure unless restrained.
I recall my dad saying that in regards to aircraft, automotive, and marine. Interestingly as a US Air Force electronic instrument technician I also recall him saying they sent him to school just for soldering.
Did you know there IS a correct way to strip wire with a knife?
-- Bob La LondeCNC Molds N Stuff-- This email has been checked for viruses by AVG antivirus software.www.avg.com
Batteries - EV Conversion
Re: Batteries - EV Conversion