Sujet : Drill chuck runout
De : Snag_one (at) *nospam* msn.com (Snag)
Groupes : rec.crafts.metalworkingDate : 15. Apr 2025, 02:45:08
Autres entêtes
Organisation : A noiseless patient Spider
Message-ID : <vtkdn6$2jbtb$1@dont-email.me>
User-Agent : Mozilla/5.0 (Windows NT 6.1; WOW64; rv:60.0) Gecko/20100101 Thunderbird/60.9.1
Mounting a drill chuck in the lathe came up , so I put one of mine in the lathe . My spindle is 3MT and the chuck tang is 2MT so an adapter sleeve was used . This is just "a chuck" , nothing special . Runout at the chuck was .003 TIR , at 12 inches from the chuck it was .012" . The rod stock I used was a piece of 1/2" O1 drill rod . The rod is over 24" long , but I did not consider sag to be a factor in the measurement I was doing .
--
Snag
We live in a time where intelligent people
are being silenced so that
stupid people won't be offended.
Drill chuck runout
Re: Drill chuck runout