Sujet : Re: A big ol' chunk of delrin
De : none (at) *nospam* none.com99 (Bob La Londe)
Groupes : rec.crafts.metalworkingDate : 19. Apr 2025, 17:41:28
Autres entêtes
Organisation : A noiseless patient Spider
Message-ID : <vu0jnn$1quq3$1@dont-email.me>
References : 1
User-Agent : Mozilla Thunderbird
On 4/18/2025 6:45 PM, Snag wrote:
Since no one currently has X axis leadscrew nuts available for my RF45 clone mill , I must make one . So I ordered a piece of acetal/ delrin . I've been studying videos of heat forming a nut to your leadscrew, all looks fairly easy . I'll use a piece probably about 2X2X3 for the nut . I bought a chunk that turns out to be 2 1/2X3X12 ... just in case it takes more than one attempt .
Let us know how it goes. I first heard of heat forming Delrin nuts right here on this group years ago. For my application I went with a spring loaded anti backlash Delrin nut from DumpsterCNC back then instead. I don't think DumpsterCNC is still around.
-- Bob La LondeCNC Molds N Stuff-- This email has been checked for viruses by AVG antivirus software.www.avg.com
A big ol' chunk of delrin
Re: A big ol' chunk of delrin