Sujet : Re: A big ol' chunk of delrin
De : joegwinn (at) *nospam* comcast.net (Joe Gwinn)
Groupes : rec.crafts.metalworkingDate : 21. Apr 2025, 22:26:48
Autres entêtes
Message-ID : <ssdd0kpdfspt4vhntckkoh99n4e06uusi0@4ax.com>
References : 1 2 3 4 5 6 7 8 9
User-Agent : ForteAgent/8.00.32.1272
On Mon, 21 Apr 2025 17:17:42 -0400, "Jim Wilkins"
<
muratlanne@gmail.com> wrote:
"Joe Gwinn" wrote in message
news:d67d0k1b0fms28q1afa8madabr02umtm7t@4ax.com...
>
From the discussion, I'd guess that it may be a ISO Trapezoidal
thread, specifically TR24x3.
>
.<https://www.engineersedge.com/hardware/iso-metric-trapezoidal-threads1.htm>
------------------------------
The Acme thread flank angle is 29 degrees, trapezoidal is 30.
Yes, but a little bit of wear will erase the distinction.
Joe
A big ol' chunk of delrin
Re: A big ol' chunk of delrin