Not quite metalworking but ...

Liste des GroupesRevenir à rc metalworking 
Sujet : Not quite metalworking but ...
De : Snag_one (at) *nospam* msn.com (Snag)
Groupes : rec.crafts.metalworking
Date : 18. May 2025, 15:08:07
Autres entêtes
Organisation : A noiseless patient Spider
Message-ID : <100cpkb$113bt$1@dont-email.me>
User-Agent : Mozilla/5.0 (Windows NT 6.1; WOW64; rv:60.0) Gecko/20100101 Thunderbird/60.9.1
   I guess spinnin' wrenches is metalwork of a sort . And I'll be doing some over the next few days/weeks . Weather permitting I'll be picking up a new to me tractor ... It's a Yanmar YM1500D , a 'compact tractor" that's still small enough to get into the woods to drag logs out for firewood . It's powered by a 2 cylinder diesel motor and comes equipped with a Bush Hog branded finish mower deck . It's been sitting for several years , but the motor turns over by hand and it has compression so it shouldn't be that hard to get it going . Oil on the dipstick is clean and shows no sign of water in the crankcase , but the fuel tank has some water , probably from condensation . Get the fuel system sorted out and change fluids and filters is where I plan to start .
--
Snag
We live in a time where intelligent people
are being silenced so that
stupid people won't be offended.

Date Sujet#  Auteur
18 May 25 * Not quite metalworking but ...7Snag
18 May 25 +* Re: Not quite metalworking but ...4Leon Fisk
18 May 25 i`* Re: Not quite metalworking but ...3Snag
18 May 25 i `* Re: Not quite metalworking but ...2Leon Fisk
18 May 25 i  `- Re: Not quite metalworking but ...1Clare Snyder
18 May 25 `* Re: Not quite metalworking but ...2Bob La Londe
18 May 25  `- Re: Not quite metalworking but ...1Snag

Haut de la page

Les messages affichés proviennent d'usenet.

NewsPortal