Re: Pin material ?

Liste des GroupesRevenir à rc metalworking 
Sujet : Re: Pin material ?
De : Snag_one (at) *nospam* msn.com (Snag)
Groupes : rec.crafts.metalworking
Date : 08. Jun 2025, 23:11:18
Autres entêtes
Organisation : A noiseless patient Spider
Message-ID : <10251qa$3b02$1@dont-email.me>
References : 1 2
User-Agent : Mozilla/5.0 (Windows NT 6.1; WOW64; rv:60.0) Gecko/20100101 Thunderbird/60.9.1
On 6/8/2025 4:49 PM, Leon Fisk wrote:
On Sun, 8 Jun 2025 16:04:09 -0500
Snag <Snag_one@msn.com> wrote:
 
   I managed to lose one of the pins that hold the lift link clevis to
the lower arms on my "new" tractor - adjustment turnbuckle was froze up
from several years sitting out in the woods . I made one from some mystery steel I have on hand but I got to wondering if I should have
used some of the 4140 I have on hand or maybe case hardened it . The
4140 is larger diameter , so more waste . I hate wasting material if I
don't have to . For all I know the piece I used is alloy , but it isn't
marked . I usually mark bought material but found or gifted stock I
don't always know what I've got so ...
 I wouldn't sweat it. Just keep on eye on it for now. See if it deforms
at all in use. I seriously doubt they're anything more than grade 2.
You can get Clevis pins from Tractor Supply or Ebay for that matter.
That is if I understand which pin your talking about correctly.
 
   It's the link that connects the lower arm to the upper arm that does the actual lifting . I have to remind myself that it's only function is lifting , it doesn't have any pulling load .
--
Snag
We live in a time where intelligent people
are being silenced so that
stupid people won't be offended.

Date Sujet#  Auteur
8 Jun 25 * Pin material ?10Snag
8 Jun 25 +* Re: Pin material ?2Leon Fisk
8 Jun 25 i`- Re: Pin material ?1Snag
8 Jun 25 `* Re: Pin material ?7Clare Snyder
8 Jun 25  +* Re: Pin material ?5Snag
9 Jun 25  i+- Re: Pin material ?1Jim Wilkins
9 Jun 25  i`* Re: Pin material ?3Clare Snyder
9 Jun 25  i `* Re: Pin material ?2Snag
9 Jun 25  i  `- Re: Pin material ?1Jim Wilkins
9 Jun 25  `- Re: Pin material ?1Jim Wilkins

Haut de la page

Les messages affichés proviennent d'usenet.

NewsPortal