Re: Pin material ?

Liste des GroupesRevenir à rc metalworking 
Sujet : Re: Pin material ?
De : clare (at) *nospam* snyder.on.ca (Clare Snyder)
Groupes : rec.crafts.metalworking
Date : 09. Jun 2025, 02:06:41
Autres entêtes
Organisation : A noiseless patient Spider
Message-ID : <2rcc4kds0mnuokj815ns0iohcac9gsjrur@4ax.com>
References : 1 2 3
User-Agent : ForteAgent/8.00.32.1272
On Sun, 8 Jun 2025 17:17:29 -0500, Snag <Snag_one@msn.com> wrote:

On 6/8/2025 5:05 PM, Clare Snyder wrote:
On Sun, 8 Jun 2025 16:04:09 -0500, Snag <Snag_one@msn.com> wrote:
 
   I managed to lose one of the pins that hold the lift link clevis to
the lower arms on my "new" tractor - adjustment turnbuckle was froze up
from several years sitting out in the woods . I made one from some
mystery steel I have on hand but I got to wondering if I should have
used some of the 4140 I have on hand or maybe case hardened it . The
4140 is larger diameter , so more waste . I hate wasting material if I
don't have to . For all I know the piece I used is alloy , but it isn't
marked . I usually mark bought material but found or gifted stock I
don't always know what I've got so ...
  I use grade 5 or grade 8 bolts as feed stock, depending on required
strength and hardness. - or even grade 3 if that is all that is
required. I go by the head markings to know what I have - - -
 
>
  This didn't start out as a bolt , it's from  a 1" piece of round
stock. Bolts are way too expensive to use as lathe stock .
 I find bolts I have are a lot cheaper than going to the metal store
to buy new metal - and with bolts I know what I have.

Date Sujet#  Auteur
8 Jun 25 * Pin material ?10Snag
8 Jun 25 +* Re: Pin material ?2Leon Fisk
8 Jun 25 i`- Re: Pin material ?1Snag
8 Jun 25 `* Re: Pin material ?7Clare Snyder
8 Jun 25  +* Re: Pin material ?5Snag
9 Jun 25  i+- Re: Pin material ?1Jim Wilkins
9 Jun 25  i`* Re: Pin material ?3Clare Snyder
9 Jun 25  i `* Re: Pin material ?2Snag
9 Jun 25  i  `- Re: Pin material ?1Jim Wilkins
9 Jun 25  `- Re: Pin material ?1Jim Wilkins

Haut de la page

Les messages affichés proviennent d'usenet.

NewsPortal