Re: Unplanned Upgrade - That Was Quick

On 7/8/2025 1:48 PM, Bob La Londe wrote:

On 7/7/2025 3:35 PM, Bob La Londe wrote:

>
>
I was steeling myself to swapping them out, but instead I walked in the office, sat down at my desk, found a unit capable of drying 75CFM and handles much higher pressure, and ordered it.

 I was about ready to go ahead and swap in my spare unit when I got an email notification the new 75CFM dryer will be arriving tomorrow.
 I wonder if it would be worth my while to plumb in the backup unit inside the machine room for redundancy?  It would only be drying already dried air anyway.
  

Or I could make a rolling service cart for my plasma cutter and put it on the bottom of the cart with the baby plasma on top.
I rarely use the plasma cutter.  I usually use one of the OA torches instead.  I usually only use the plasma on aluminum when I saw won't do.
--
Bob La Londe
CNC Molds N Stuff
--
This email has been checked for viruses by AVG antivirus software.
www.avg.com