Re: [Brushcutter] Need trimmer head for big cords

Good afternoon.

This morning, wisdom caught up with me although I am running fast.

While contemplating some *round* and *twisted* trimmer cords in two different
shops, the only interesting thing was my impression that 3mm were smaller than
the size of my square cord.

At home, suddenly old Pytagoras  ➤1 hit me hard in the head.

To conclude: a square cord of 3mm means that the width is 3mm, for a round cord
it is the diameter, for a twisted cord only the distance between the extreme
outer edges of the cross section.

The diagonal of the square is however 4,24mm !!!

I do not want to know, why the only indication you see is 3mm, while the
trimmer head must support over 4mm.

All that follows is historic and came from a blurred mind.

Have a nice week-end.

Michael Uplawski hat geschrieben:

>
Good morning from France
>
I need a new trimmer head for a Honda 435 UMK-E (four-stroke)
brushcutter. My favorite cord size is 3mm. I can look that up in
inches but do not really want to. Let's say big cords, the bigger
the better.

(,,,)

My current trimmer head *does work*, but after a few minutes in
a real thicket, the cord is seized in its furrow and would not sort,
when I need to extend it anew.v

──────────────────
1) <https://wikiless.tiekoetter.com/wiki/Pythagoras?lang=en>
--
Geh Kaffee kochen