Op-amp mystery

It's always the stupid things that cause the most trouble:

I was working on a fairly straightforward experimental audio circuit
using TL074 op-amps laid out on Veroboard, which is prone to inter-track
shorts unless you are very careful with your soldering.   The gain of a
virtual-earth stage was too high, so I altered some resistor values to
cut it down. 

As this was a stereo system, I experimented with one channel first and
then switched off and replaced the equivalent resistors in the second
channel (one of the other op-amps in the same chip).

The input signal was a 6 Kc/s sinwave at about -10 dBu.  After the
modification, the volume control, which was in a feedback loop, didnt
seem to make much difference.  Then I realised that applying the signal
to the left channel gave a distorted version of it in the right channel
and vice-versa.  Obviously I had shorted two tracks somewhere - but
where?

Things got even worse when I realised that the input signal was
appearing on the virtual earth input of each op-amp, this definitely
can't happen!  I decided it was time to switch off the power supply and
go and ponder the problem over a cup of tea.

That was the point where I discovered I hadn't switched the power supply
on in the first place.

--
~ Liz Tuddenham ~
(Remove the ".invalid"s and add ".co.uk" to reply)
www.poppyrecords.co.uk