Re: high curent PCB connector

On Sun, 23 Feb 2025 20:03:46 +0100, Lasse Langwadt <llc@fonz.dk>
wrote:

On 2/23/25 16:45, john larkin wrote:

On Sun, 23 Feb 2025 14:02:30 +0100, Lasse Langwadt <llc@fonz.dk>
wrote:
 

On 2/14/25 17:37, john larkin wrote:

Does anyone have a favorite high-current PCB connector?
>
I'd like to get 20 wires into a pluggable connector, to go on a module
like this:
>
https://highlandtechnology.com/Product/P948
>
We need at least 7 amps per contact.
>
That litle green Phoenix connector is cool. Wires screw into it
without tooling, and it's easy to mate and unmate. But it's only 5
pins.
>
I was planning to use four of them, with two on a baby board, but that
idea wasn't popular.
>

>
https://www.mouser.ca/ProductDetail/Phoenix-Contact/1842979?qs=aYsvlkyO7qM1vWO95kklEQ%3D%3D

 
The problem with those connectorfs, and the Weidmuller equivalents, is
that humans aren't strong enough to un-mate them. And the spring-push
wire clamps are flakey. And that they have no no opinions about pin
numbering.
 

>
We've used a lot of those plugable connectors, never seemed like a
problem to unmate them

We used a similar part, and it was very hard to un-mate. We use the
version with the cam now, but only a few of their connectors have the
un-mate cam.

https://www.digikey.com/en/products/detail/phoenix-contact/1808912/3439844

>
doesn't have to be spring clamps,
https://www.digikey.dk/da/products/detail/phoenix-contact/1803633/260535
>
if there no number you decide what to call the pins

And since the connectors are unmarked, we have to explain the pin
numbering to our customers, with pictures in manuals.