Re: High purity 1kHz oscillator

On Tue, 22 Oct 2024 01:10:41 -0400, "Edward Rawde"
<invalid@invalid.invalid> wrote:

But I suspect that component tolerances and mismatched FETs will ruin it.

The very best bulk metal foil resistors have voltage-resistance
coefficients of a few ppm/volt. Most resistors are much worse.

Just the resistors can kill distortion specs. At low frequencies,
self-heating and tempco can add distortion too; the old HP oscillators
had that effect from the lamp filament.

DGMS on capacitor nonlinearity.