Sujet : Re: RF Connector Type ID
De : jrwalliker (at) *nospam* gmail.com (John R Walliker)
Groupes : sci.electronics.designDate : 08. Jun 2024, 22:54:07
Autres entêtes
Organisation : A noiseless patient Spider
Message-ID : <v42ju0$2gbeq$2@dont-email.me>
References : 1 2 3
User-Agent : Mozilla Thunderbird
On 08/06/2024 22:47, John R Walliker wrote:
On 08/06/2024 20:43, john larkin wrote:
On Sat, 8 Jun 2024 18:10:59 -0000 (UTC), Cursitor Doom
<cd999666@notformail.com> wrote:
>
Gentlemen,
>
Can anyone identify these connectors? HP use 'em an awful lot for
interconnecting the boards of their analyzers to route 50 ohm RF signals
around the various inside sections.
>
Thanks,
>
CD.
>
https://disk.yandex.com/i/LQ1ytGUQCf7OTw
>
Probably SMBs.
+1
John
Most of the connectors in the image look like SMB which is a "click on"
push fit connector and is cylindrical at the end. A few which have a hex profile at the end may be SMC which is a threaded connector.
SMA is threaded and a bit larger, but has the best high frequency performance of them all.
John
RF Connector Type ID
Re: RF Connector Type ID
