Re: SPLD output current protection

I have an SPLD with about 8 terminals exposed to the user I'd like to
protect against over current. They're very low-speed outputs (10s of Hz
at most), don't really want to spend a bunch for a chip like the L6374
as an intermediary, or the board space for a bunch of transistors to
discrete limit...
 
The SPLD has a max per-chip-side Vdd input current of 45 mA at 85 C TJ
and 22 mA at 110 TJ, and can sink 86 mA to ground per side, 41 at 110 TJ.
 
The outputs are configured as push-pull or open drain, depending on the
firmware/application, either way they can source or sink 40mA in
isolation. But no more than two outputs per side at a time will be in a
state such that they can sink/source current either way.
 
The uP I'm using has a very nice 10 bit differential ADC (9 bits if used
in bipolar mode) I'm thinking about just rigging it to two 4051s to
"scan" a current sense in each output line to implement the overcurrent,
can set different thresholds based on whether it's configured push-pull
or OD, but what might conservative limits be? And what rate to scan?
 
The SPLD is acting as a simple power supervisor and has a PWR GOOD line
to bring up the uP. In turn it gets a clock from the uP, I can set up
the SPLD to set all those outputs hi-z if it ever loses the clock (i.e.
uP hangs) as an extra layer of protection..