Re:mountable power ports

Christopher Howard <christopher@librehacker.com> Wrote in message:r

Hi, my project box is a large tin cookie box. I need to bring in +15V,-15V, and GND lines from my external bipolar power supply. (I wasthinking I would have a separate bolt for the chassis ground, whichwould go off to a big ground bus bar near my workbench.) For the threelines from the power supply, I am wondering what would be the best (buteconomical) choice for a power connector to mount into the side of theproject box. Something that sounded appealing was the spring speakerterminal clips I see on Amazon, but the downside there is they only comein pairs of two or four, rather than three, and they are color codedred/black which does not quite make sense here. I am inclined to leavethe wires on the power supply itself bare on the end, rather thanattaching some specialty connector to those.-- Christopher Howard

If its rather low current,   coaxial power plug and Jack, or even
 a 1/4" stereo Jack. I prefer the binding posts.

Cheers
--


----Android NewsGroup Reader----
https://piaohong.s3-us-west-2.amazonaws.com/usenet/index.html