Re: PSU Ripple Update

On 18/03/2024 6:47 am, Cursitor Doom wrote:

On Sun, 17 Mar 2024 20:20:58 +0100, Jeroen Belleman
<jeroen@nospam.please> wrote:
 

On 3/17/24 18:48, Cursitor Doom wrote:

<snip>

Now I did check to see if there was anything downstream which had
shorted or gone low-resistance which could possibly account for this,
but found nothing amiss. So the question is:
What could cause ripple to arise when even very light loads are
applied to the output of a pretty substantial linear PSU?
>
BTW, the bridge rectifiers were fine and have been exonerated from any
culpability in this fault.

>
Isn't that what you'd expect? The storage capacitor gets topped
up twice per mains period. In between top-ups, it's the sole source
of the output current, so its voltage drops until the next top-up.
>
You could measure the rate of voltage drop and check if it has the
expected slope for the output current and the storage cap's value:
dV/dt = -I/C.
>
You could also check if the pass transistors still have enough
voltage across them at maximum current and just before the next
top-up. Do you see ripple on the regulated output?

 Not only am I seeing ripple on the regulated output, I'm seeing it on
the final output of the signal generator this PSU powers.

That sounds as if the linear regulators aren't regulating.
You need to compare the voltages applied to the inputs of the regulators, which can be expected to show appreciable ripple with the nominally regulated output, which shouldn't. Any residual output ripple should be a couple of orders of magnitude smaller than the input ripple.

It's quite a beefy PSU, but as little as 90mA draw gives rise to an
unacceptable level of ripple which permeates through the whole of the
downstream circuitry.

It may be "beefy" but it doesn't seem to be working as it should.
--
Bill Sloman, Sydney