Sujet : Re: Practical resistor accuracy distribution
De : jjSNIPlarkin (at) *nospam* highNONOlandtechnology.com (John Larkin)
Groupes : sci.electronics.designDate : 27. Apr 2024, 01:47:40
Autres entêtes
Organisation : Highland Tech
Message-ID : <8reo2jd6545ddln1elkq2een9tmle6ard7@4ax.com>
References : 1
User-Agent : Forte Agent 3.1/32.783
On Sat, 27 Apr 2024 00:54:41 +0200, Klaus Vestergaard Kragelund
<
klauskvik@hotmail.com> wrote:
Hi
>
I needed to look into distribution of accuracy of resistors.
>
Vendors don't have any info, but luckily some nice people online have
done measurements:
>
https://www.eevblog.com/forum/projects/smd-resistor-distributions/
>
https://lambdafox.com/resistor-tolerances/
>
Regards
>
Klaus
Are resistors usually low to save time laser trimming?
Are resistors on the same reel closer than parts from another reel?
The Susumu thinfilms are really good.
Practical resistor accuracy distribution
Re: Practical resistor accuracy distribution
