Re: Optocoupler datasheets

On Thu, 30 May 2024 11:29:18 -0000 (UTC), Phil Hobbs
<pcdhSpamMeSenseless@electrooptical.net> wrote:

piglet <erichpwagner@hotmail.com> wrote:

On 29/05/2024 17:39, Phil Hobbs wrote:

On 2024-05-29 11:56, piglet wrote:

bitrex <user@example.net> wrote:

Optocoupler datasheets seem like kind of a mess, I try not to use them
too often in situations where there's any kind of power budget because
other than "shove some relatively huge current through the LED like 5-10
mA" it's hard to know what you can get away with.
 
A light load on the transistor side will definitely reduce the forward
current required (and of course slow the speed to a crawl) but who can
say by how much while still ensuring the thing will turn on sufficiently
to saturate the output?
 
The CTR varies widely from process variation, varies with temperature,
varies with collector emitter voltage, varies with forward current, and
the data sheets are full of caveats like "At I_f < 1 mA, note CTR
variation may increase" and "Graphs are representative, not indicative
of actual performance." ????
 
Any suggestions for how to approach methodically/mathematically
selecting drive current would be appreciated, thank you! ("Don't bother"
a valid option)
 

 
Why do you want to saturate the photo transistor?
If you don’t you can get much higher speeds out of even jelly bean cheap
couplers. Even without a base connection it is possible.
 

Because unless there's overall feedback, running it unsaturated gives
you a beta-dependent circuit that's further dependent on the LED
efficiency, the transparency of the white snot filling the opto package,
temperature, you name it.
 
Cheers
 
Phil Hobbs
 

 
Sorry, maybe my language was sloppy. I meant keep phototransistor
collector from bottoming and reduce C-B miller effect. Not necessarily
by rationing photons. Keeping Vce constant by feeding straight into a
transistor base is brutally effective. See the post about halfway down here:
 
<https://electronics.stackexchange.com/questions/136928/under-what-conditions-does-an-optocoupler-work-fastest>
 
piglet
 
 
 

>
If you have the base pinned out, you can do more stuff, true.  But at the
end of the day you’re still dealing with a phototransistor. 
>
BITD TI and HP made optos with actual specs, but these days, not so much.
>
Linear mode works great when there’s overall feedback, as in your typical
offline switcher, which has a TL431 to do the actual regulating.
>
Cheers
>
Phil Hobbs

A c-b schottky clamp would help, sort of a 74LS photocoupler.

But the really good logic couplers these days aren't optical.