Re: British (european?) kitchen counter electric outlets

In the US, we are required (new construction) to have two dedicated 20A
(2400W) circuits to service countertop "small appliances".  In addition,
there is also a requirement for a relatively tight spacing between
(duplex) receptacles -- the intent to keep cords short (IIRC, < 4ft...
we settled on 3').
>
SWMBO was watching a britcom

and commented at how few receptacles/outlets were in evidence to serve the countertop.

 Granted, each outlet is rated a
fair bit higher than US (each US outlet being 2400W -- the full load rating
of the branch circuit supporting it).  But, still, how do you address
NUMBERS of appliances in use, concurrently -- where each appliance will
likely draw only a fraction of the rated branch circuit's current so
total load isn't an issue?
>
E.g., we (presently) have a ~1KW microwave oven and a ~1KW toaster as
ever-present loads.  To that, it is not uncommon to add an electric
wok, hand or stand mixer, pizzelle iron, etc.  The abundance of
outlets makes it easy to add appliances as well as providing flexibility
over where they can be put into use.