Re: Fast monostable with a transistpor array

On 6/14/2024 12:33 PM, john larkin wrote:

On Fri, 14 Jun 2024 12:18:23 -0400, "Edward Rawde"
<invalid@invalid.invalid> wrote:
 

"john larkin" <jl@650pot.com> wrote in message news:8epo6jhf5k5nbkkqp5ot9b6nq1lhoia870@4ax.com...

On Fri, 14 Jun 2024 11:08:56 -0400, "Edward Rawde"
<invalid@invalid.invalid> wrote:
>

>
"john larkin" <jl@650pot.com> wrote in message news:hilo6j9dgctalpiu4v09rpdavf6fetm1cv@4ax.com...

On Thu, 13 Jun 2024 23:25:37 -0400, "Edward Rawde"
<invalid@invalid.invalid> wrote:
>

"Bill Sloman" <bill.sloman@ieee.org> wrote in message news:v4f2nm$2augj$1@dont-email.me...

One option John Larjkin doesn't seem to have explored is using Renesas HFA3096 five transistor array as basis for his
mononstable
and level shifter.
>
It offers three 8GHz NPN parts and two 5.5GHz PNP parts in a single array.
>
https://www.renesas.com/us/en/document/dst/hfa3046-hfa3096-hfa3127-hfa3128-datasheet?r=494216
>

>
I put the NPN model parameters into a circuit designed by yourself.
It's late now but I got as far as Time step too small.
>

>
That is neither fast nor a monostable.

>
Yes ok it's an astable and certainly not intended to be fast.
It was intended only to see if the model worked. Nothing more.

>
It doesn't work!
>

>

>
There's no reason to use many-GHz parts in micropower circuits. One
reason is that the sim breaks.

>
Most versions of the HFA3046 are obsolete. The only one left at
Digikey costs $12. It would be risky to design around that part.

>
If it's obsolete or going obsolete then yes it would make no sense to use it.
I would guess that you get to do plenty of work because a manufacturer has suddenly decided to discontinue a part.
>

Wasn't  HFA originally a Harris part?
>
There are lots of dual (non-monolithic) diodes and bipolars and fets
around, but the monolithic arrays are mostly gone.

>
What part would you recommend (single or dual) and does it have a working LTSpice model?

 Just pull up some parts from the standard library, some low current
NPNs like BC547 maybe. Look for low capacitances if you care about
that; the HFAs are good in that respect.
 Why do people avoid making clean 4-wire connections on schematics?

There's this new trend of breaking the circuit schematic up into little boxes like this, it's nuts:
<https://hackaday.com/wp-content/uploads/2024/05/hadimg_desrev_ltc4040_6.png>