Sujet : Re: another fast one-shot
De : bill.sloman (at) *nospam* ieee.org (Bill Sloman)
Groupes : sci.electronics.designDate : 24. Jun 2024, 04:34:58
Autres entêtes
Organisation : A noiseless patient Spider
Message-ID : <v5am0i$njkq$2@dont-email.me>
References : 1 2 3 4 5 6 7 8 9
User-Agent : Mozilla Thunderbird
On 24/06/2024 3:36 am, john larkin wrote:
On Sun, 23 Jun 2024 17:01:45 -0000 (UTC), Cursitor Doom
<cd999666@notformail.com> wrote:
On Sun, 23 Jun 2024 11:38:28 +1000, Bill Sloman wrote:
>
On 22/06/2024 3:23 pm, john larkin wrote:
On Fri, 14 Jun 2024 19:02:11 +0100, piglet <erichpwagner@hotmail.com>
wrote:
>
On 13/06/2024 07:03, Bill Sloman wrote:
On 13/06/2024 4:11 am, john larkin wrote:
On Wed, 12 Jun 2024 17:22:49 -0000 (UTC), Cursitor Doom
<cd999666@notformail.com> wrote:
>
On Wed, 12 Jun 2024 09:33:17 -0700, john larkin wrote:
<snip>
There are some screamingly fast CMOS gates and flops around that cost
pennies.
And there have been for years. You started this thread with a pencil sketch that included an 10EP51 ($6.53) and an ADCMP562 ($3.15).
Two BFR92 ($0.64 each)and couple of resistors and capacitors can do the same job, if you know what you are doing.
You pencil sketch didn't tell us much about what you were trying to do, or why, and nothing much about the input - "Trig In" as a balanced PECL signal tells us about the signal levels, but nothing else.
As an effort to look like a circuit designer, it wasn't impressive.
-- Bill Sloman, Sydney-- This email has been checked for viruses by Norton antivirus software.www.norton.com