Re: uP port mapping

On 12/09/2024 22:28, Theo wrote:

In comp.sys.raspberry-pi john larkin <jl@650pot.com> wrote:

RP2040 has I think 2 PIO blocks and each has a couple of hardware
programmable state machines, and those can be set up to drive pins.
I'm mostly concerned now with a PCB schematic design, picking the
appropriate and easy-to-route pins from the CPU to things.
>
My general question, for various processors, is how to associate bits
in integer variables with physical pins on the chip.

 This is the function of a 'pinmux'.  Different chips have different
capabilities of the pinmux, but it's rare to be able to connect any GPIO to
any pin - that's more FPGA territory.  Typically the pinmux is just about
selecting one of multiple fixed functions for a given pin
(SPI1_MISO/I2C3_SDA/UART2_TX/...)
 

That is my understanding, too.  What the pins do is programmable, but not tire mappings to specific registers  inside the processor

So either you route your DAC to consecutive pins (D0 to GPIOn, D1 to n+1,
..., ideally where n is a multiple of 8), or you're prepared to do the
necessary bit shuffling in software (which can be slow and non-atomic).  I'd
suggest sticking to consecutive ordering if you can.
 

Yes.

(although I have no experience of the RP2xxx GPIO/PIO shenanigans)
 

I have - a very very little - but I have spent some time reading the docs to see at least if the Pi PICO is suitable for various speculative projects or not.
There is a massive amount of shit it *can* do that probably only one person in a hundred would ever use.
It just so happens that driving parallel connected external logic is something I have an interest in, so I read that bit... :-)

Theo

--
Civilization exists by geological consent, subject to change without notice.
  – Will Durant