Re: power supply discharge

On Sat, 28 Sep 2024 10:21:46 -0700, john larkin <JL@gct.com> wrote:

On Sat, 28 Sep 2024 09:44:44 -0400, legg <legg@nospam.magma.ca> wrote:
>

On Fri, 27 Sep 2024 08:07:29 -0700, john larkin <JL@gct.com> wrote:
>

>
Given a benchtop power supply, you can turn the voltage up and then
down, and it goes down. Most have a substantial amount of output
capacitance, and can be driving an external cap too. So something
pulls the output down.
>
I guess that there are no standards for this, but I've never seen a
supply that just hangs high when it's cranked down.
>
I'm designing some programmable multi-channel power suplies and that
is one of many tangled issues in the project.

>
Twiddling the adjustment knob on a bench supply doesn't
represent a dramatic change - and most adjustible
supplies don't load their output terminals with a
lot of capacitance.

>
I've measured a few, and got output terminal capacitance of a few
hundred to maybe 2000 uF.
>
People here might measure some random power supplies. I leave them off
and connect to a 50 ohm sinewave-output function generator and find
the -3 dB point. One could use a square wave and scope the slopes too.
Keeping the amplitude low will avoid turning semi junctions on.

Come on guys, quit pontificating and start measuring.