Sujet : Re: Cheaper alternative to IRLML2060
De : erichpwagner (at) *nospam* hotmail.com (piglet)
Groupes : sci.electronics.designDate : 23. Oct 2024, 19:14:28
Autres entêtes
Organisation : A noiseless patient Spider
Message-ID : <vfbee4$254p3$1@dont-email.me>
References : 1 2 3 4 5 6
User-Agent : NewsTap/5.5 (iPhone/iPod Touch)
piglet <
erichpwagner@hotmail.com> wrote:
john larkin <JL@gct.com> wrote:
On Wed, 23 Oct 2024 16:51:06 +0530, Pimpom <Pimpom@invalid.invalid>
wrote:
On 23-10-2024 03:32 pm, piglet wrote:
piglet <erichpwagner@hotmail.com> wrote:
Pimpom <Pimpom@invalid.invalid> wrote:
I've been looking for some time for a jelly bean MOSFET with these specs:
Id(max) ~1A
Vds >/= 30V
Rds(on) <1 ohm
Qg <1nC
Ciss <100pF
A big brother to the 2N7000/7002. The IRLML2060 seems to fit the bill
nicely but I'm having trouble finding it here in India. A bit pricey for
a jelly bean part anyway.
Any suggestions?
BSS316 ?
AO3400 family are cheap but miss your gate charge spec
I have AO3400 & 3401, about US$0.03 from AliExpress before India blocked
the site. But these are 4-5A devices with correspondingly higher Qg and
Ciss.
I need to switch about 1 amp at up to 80 volts into a resistive load,
preferably logic level gate, and board area is critical. A dpak is
kinda big. I wish some SOT23 could do it
I don't understand why anyone would bother to make a mosfet for 3
cents, or a diode for 1 cent, or a resistor for a tenth of a cent.
PMV213 or DMN10H220 ?
My bad the PMV is 10V gate, the DMN is 5V
-- piglet