Sujet : Re: Rectification
De : liz (at) *nospam* poppyrecords.invalid.invalid (Liz Tuddenham)
Groupes : sci.electronics.designDate : 03. Nov 2024, 19:18:28
Autres entêtes
Organisation : Poppy Records
Message-ID : <1r2gbhq.12374o41qieggsN%liz@poppyrecords.invalid.invalid>
References : 1 2 3 4 5
User-Agent : MacSOUP/2.4.6
Bill Sloman <
bill.sloman@ieee.org> wrote:
On 3/11/2024 1:56 am, Liz Tuddenham wrote:
Cursitor Doom <cd@notformail.com> wrote:
On Sat, 2 Nov 2024 13:48:47 +0000, liz@poppyrecords.invalid.invalid
(Liz Tuddenham) wrote:
>
Cursitor Doom <cd@notformail.com> wrote:
>
... At still higher frequencies, the inherent capacitance
of the diode is leaving just a flat DC voltage with no longer any
peaks visible.
>
I would have thought, if the load was resistive, you would just see the
A.C. waveform, as the self-capacitance of the diode swamped out all the
other effects. If you have a smoothing capacitor following the diode,
that would effectively be in series with the diode's self capacitance
and the two of them would act as a capacitive divider which
progressively shorted out the power supply as the frequency increased.
>
Yes, indeed, I'm sure a tank cap would be a short at relatively low
frequencies so I didn't envisage one for this particular mind
experiment.
I'd like to try it in Spice but I don't think the available diode
models are up to the job.
Bear in mind that there are a lot of different types of diodes and some
are used as mixers up to SHF, so you might have to simulate low
infra-red before you noticed an non-diode behaviour with them.
Something like a 1N4001 would be more manageable.
I've seen the 1N4001 used as a varactor diode.
I wonder if it would make a noiseless parametric amplifier for audio
frequencies?
-- ~ Liz Tuddenham ~(Remove the ".invalid"s and add ".co.uk" to reply)www.poppyrecords.co.uk