brickwalled relays

I put all the relays that would fit on the board.

https://www.dropbox.com/scl/fo/pz4axx3pmyl3a6fmyef8e/AOP8q-Z_KeMtiv8TgslL9CQ?rlkey=imu35x1qvt9j8j29if1b1vgm5&dl=0

The blue wires were my mistake. I put test points on both ends of two
signals on separate schematic sheets, and somehow that let it pass a
connectivity check. On the other hand, the test points make the
jumpering work nicely.

So far, that's all that seems to be wrong.

It's our FITS cable fault insertion module, for our P940 modular power
system.