Re: mountable power ports

On 3/26/25 16:56, Christopher Howard wrote:

Hi, my project box is a large tin cookie box. I need to bring in +15V,
-15V, and GND lines from my external bipolar power supply. (I was
thinking I would have a separate bolt for the chassis ground, which
would go off to a big ground bus bar near my workbench.) For the three
lines from the power supply, I am wondering what would be the best (but
economical) choice for a power connector to mount into the side of the
project box. Something that sounded appealing was the spring speaker
terminal clips I see on Amazon, but the downside there is they only come
in pairs of two or four, rather than three, and they are color coded
red/black which does not quite make sense here. I am inclined to leave
the wires on the power supply itself bare on the end, rather than
attaching some specialty connector to those.
 

there are million of different connectors, leaving the wires bare is just asking for getting the connections wrong ..