Re: comparator with two analog switches

Liste des GroupesRevenir à se design 
Sujet : Re: comparator with two analog switches
De : invalid (at) *nospam* invalid.invalid (Edward Rawde)
Groupes : sci.electronics.design
Date : 29. Apr 2025, 16:24:52
Autres entêtes
Organisation : BWH Usenet Archive (https://usenet.blueworldhosting.com)
Message-ID : <vuqr07$1hb$1@nnrp.usenet.blueworldhosting.com>
References : 1 2
User-Agent : Microsoft Outlook Express 6.00.2900.5931
"Christopher Howard" <christopher@librehacker.com> wrote in message news:877c34qnax.fsf@librehacker.com...
"Edward Rawde" <invalid@invalid.invalid> writes:
>
What's on pin 12 ?
>
>
Pin 12 on the switches is for a logic power supply that was needed on
the "original manufacturer's products" but is not needed on the Maxim
chips.

Ok but it's hard to help if there is much we don't know about what you're using or what you're trying to achieve.
If the original problem was not wanting to use 5V for a schmitt trigger then make one out of a couple of transistors or an op amp
with positive feedback.
https://en.wikipedia.org/wiki/Schmitt_trigger

>
--
Christopher Howard



Date Sujet#  Auteur
25 Apr 25 * comparator with two analog switches9Christopher Howard
25 Apr 25 +* Re: comparator with two analog switches6Edward Rawde
25 Apr 25 i+* Re: comparator with two analog switches4Christopher Howard
25 Apr 25 ii`* Re: comparator with two analog switches3Edward Rawde
28 Apr 25 ii `* Re: comparator with two analog switches2Christopher Howard
29 Apr 25 ii  `- Re: comparator with two analog switches1Edward Rawde
25 Apr 25 i`- Re: comparator with two analog switches1john larkin
25 Apr 25 +- Re: comparator with two analog switches1piglet
25 Apr 25 `- Re: comparator with two analog switches1JM

Haut de la page

Les messages affichés proviennent d'usenet.

NewsPortal