Sujet : Cap C-V test
De : jl (at) *nospam* glen--canyon.com (john larkin)
Groupes : sci.electronics.designDate : 01. May 2025, 21:09:50
Autres entêtes
Organisation : A noiseless patient Spider
Message-ID : <sik71k9uvbqacp964bvlc5317ga12gu9al@4ax.com>
User-Agent : ForteAgent/8.00.32.1272
https://www.dropbox.com/scl/fi/a7425c69k3w8wx8tqjpq5/X110_CV_Test.jpg?rlkey=pc3c0b12ncswv6ajrn148stdk&raw=1The DUT is a Venkel 2.2 uF 100v 1812-size ceramic cap. I need to run
it at 48 volts. 0.8 uF is probably OK. I have room on my board so I
guess I'll add another cap in parallel.
My AADE cap meter was behaving strangely here, so I measured C by
noting the -3 dB frequency driving the cap from a 50 ohm sine wave
generator.
Cap C-V test
Re: Cap C-V test