Sujet : Re: Is it a capacitor, is it a resistor?
De : mr.spock (at) *nospam* spockmall.net (jim whitby)
Groupes : sci.electronics.repairDate : 14. Mar 2024, 23:31:33
Autres entêtes
Organisation : A noiseless patient Spider
Message-ID : <usvqbl$1rqj0$1@dont-email.me>
References : 1
User-Agent : Pan/0.149 (Bellevue; 4c157ba git@gitlab.gnome.org:GNOME/pan.git)
I was asked to repair a Pioneer QX-949 quadraphonic tuner/amplifier. It
is a complex beast and one channel had gone down to almost nothing.
Luckily the service sheet was available and I traced the fault to the
board which houses the tone controls and filters.
The gain is in two stages with the tone controls around the second
stage. On one of the channels, the voltages on the single transistor
for that stage were all wrong. After lifting the transistor off the
board, it became apparent that the base bias was far too high and the
finger of suspicion pointed to the inter-stage coupling capacitor
feeding in leakage current from the preceding stage.
I tested the capacitor, which was marked "4.7". It read exactly 4.7k in
both directions on an ohm-meter !!!
You have a new type of device! Save it. It just might be worth
something... someday... maybe...
-- Jim WhitbyFor the next hour, WE will control all that you see and hear.----------------------
Mageia release 9 (Official) for x86_64
6.6.18-server-1.mga9 unknown
----------------------