Re: Alps rotary encoder ID

On Sun, 5 May 2024 21:42:04 -0400, "UFO" <tech@parts-link.net> wrote:

That hit on Reddit is exactly the same board, so that must be how the
original shaft looks.
I am thinking Alps EC11 like these  https://www.ebay.com/itm/113261494197
and the comments on reddit says they went with an EC11.

Note that the "11" in EC11 means that the base is 11mm x 11m.  You
should be able to measure the broken encoder with a rules.

Also, I think the Alps Encoder Product FAQ might be useful:
<https://tech.alpsalpine.com/e/products/faq/encoder/>

This is there selection of EC11 encoders:
<https://tech.alpsalpine.com/e/products/category/encorders/sub/01/series/ec11e/>

--
Jeff Liebermann                 jeffl@cruzio.com
PO Box 272      http://www.LearnByDestroying.com
Ben Lomond CA 95005-0272
Skype: JeffLiebermann      AE6KS    831-336-2558