Terminal block usage.

Sujet : Terminal block usage.
De : peter (at) *nospam* easthope.ca
Groupes : sci.electronics.repair
Date : 06. Jul 2024, 04:44:19

Autres entêtes

Organisation : A noiseless patient Spider
Message-ID : <v6aeij$3lntq$1@dont-email.me>
User-Agent : Oberon Mail (ejz) on LinuxA2 Gen. 64-bit, rev.9799

Hello again,

I'll be connecting wires to the terminal block of a motor controller.
Two connections will each have two wires as illstrated here.
http://easthope.ca/TerminalBlock.jpg

Soldering the pair of wires together will keep them aligned when
inserting. I understand that solder creeps. Is solder prohibited in
this application? OK if applied sparingly?

Should conductive paste be applied?

Thanks, ... Peter E.

Date	Sujet	#	Auteur
6 Jul 24	Terminal block usage.	5	peter
6 Jul 24	Re: Terminal block usage.	1	HW
6 Jul 24	Re: Terminal block usage.	3	legg
22 Jul 24	Re (2): Terminal block usage.	2	peter
7 Aug 24	Re: Re (2): Terminal block usage.	1	Marc Lewis

Haut de la page

Les messages affichés proviennent d'usenet.

NewsPortal