Sujet : Re: Question about a Linde Utility Welder 230
De : djb (at) *nospam* invalid.com (David Billington)
Groupes : sci.engr.joining.weldingDate : 25. Jun 2024, 22:00:16
Autres entêtes
Organisation : A noiseless patient Spider
Message-ID : <v5fb51$1mm17$1@dont-email.me>
References : 1 2
User-Agent : Mozilla Thunderbird
On 25/06/2024 21:15, Shannon wrote:
can you still get leads for these?
>
A quick look seems to show a quick connect but not enough detail to show what type. Dinse are quite a common fitting IME and readily available from good welding suppliers and ebay. Make your own leads as they're easy to fit and I've swapped some stud panel fittings for Dinse in the past and they were a direct swap.
Re: Question about a Linde Utility Welder 230
Re: Question about a Linde Utility Welder 230