Re: 309SS or ER70S6

Liste des GroupesRevenir à sej welding 
Sujet : Re: 309SS or ER70S6
De : muratlanne (at) *nospam* gmail.com (Jim Wilkins)
Groupes : sci.engr.joining.welding rec.crafts.metalworking
Date : 23. Jul 2024, 17:43:37
Autres entêtes
Organisation : A noiseless patient Spider
Message-ID : <v7omlb$19mbs$1@dont-email.me>
References : 1 2 3 4
User-Agent : Microsoft Windows Live Mail 16.4.3505.912
"David Billington"  wrote in message news:v7ojqb$17lro$1@dont-email.me...
On 23/07/2024 16:12, Snag wrote:
...
If a spare part is available then I would use that unless prohibitively
expensive. What sort of welder are you using. I refurbish glassblowing
jacks occasionally using a TIG welder and O1 as filler and that leaves
quite a hard deposit that I temper once built up to the required level.
It's like welding on the edge of a blunt knife blade and worthwhile
considering what new ones cost so long as they haven't worn so much it's
beyond saving.
----------------------------
I built up and ground down the edge of a splitting maul my uncle had used to chip a lump off the granite front step. Wrecking the tool was preferable to displeasing his mother. A 7" angle grinder dressed the weld neatly and easily.

Date Sujet#  Auteur
23 Jul 24 * 309SS or ER70S69Snag
23 Jul 24 +* Re: 309SS or ER70S65Jim Wilkins
23 Jul 24 i`* Re: 309SS or ER70S64Snag
23 Jul 24 i `* Re: 309SS or ER70S63David Billington
23 Jul 24 i  +- Re: 309SS or ER70S61Jim Wilkins
23 Jul 24 i  `- Re: 309SS or ER70S61Snag
23 Jul 24 `* Re: 309SS or ER70S63Bob La Londe
23 Jul 24  `* Re: 309SS or ER70S62Snag
23 Jul 24   `- Re: 309SS or ER70S61Jim Wilkins

Haut de la page

Les messages affichés proviennent d'usenet.

NewsPortal